Gasboy CFN Site Controller Manual do Utilizador descarregar pdf (Página 62)

54 Pump Control Unit Pump Interface Manual v1.3

Gasboy CFN Series 03/20/03

DIP Switch Bank C

Note: In connection with pulser enabled, there are two error codes, each with three characters,

that can show up in the error column on a transaction printout. The reset-failed-to-start

transaction code is $D2 through $DF, and the reset-failed-to-complete transaction code is $E5

through $EF ($ indicates hexadecimal). The last character in each code (2 through F or 5 through

F) is the number of seconds the PCU waited for reset to start or complete. This numeric character

is incremented by one each time the PCU reset-to-start/complete times out, until the maximum

time-out of 15 (15 is F in hexadecimal counting) seconds is reached.

Test Mode. When test mode is activated with switch C-8, switch C-5 determines the relay limits:

In test mode, switches C-6 and C-7 select the pump to be tested:

Address B-1 B-2 B-3 B-4

1 clclclcl

2 opclclcl

3 clopclcl

4opopclcl

5 clclopcl

6opclopcl

7 cl opopcl

8 opopopcl

9 clclclop

10 op cl cl op

11 cl op cl op

12 op op cl op

13 cl cl op op

14 op cl op op

15 cl op op op

16 op op op op

Position & Definition Setting(*=customary)

1-4 pulser enabled (pumps

1-4)

(see note below)

closed=after reset is

complete

open=upon activation

5____

6 dead man timer *always open=enabled

7____

8 test mode *closed=no

open=yes

C-5 Function

open pump slows at 500 pulses and turns off at 510 pulses

closed pump slows at 50 pulses and turns off at 60 pulses

Pump to Test C-6 C-7

1 closed closed

2openclosed

3closedopen

4openopen

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68 69 70

Comentários a estes Manuais

Sem comentários

Gasboy CFN Site Controller Manual do Utilizador Página 62

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Gasboy CFN Site Controller