Gasboy CFN Series Site Controller III Manual do Utilizador descarregar pdf (Página 14)

System Layout SC III

Page 10 MDE-4298D CFN Series Site Controller III Installation Manual · September 2009

In addition to SC ports, Personal Computer (PC) peripherals (monitor, mouse, and so on) are

connected as per the manufacturer’s instructions. Figure 3-1 shows SC ports as installed on a

representative PC (your actual PC layout may differ).

Location

The SC III should be located in an office-like environment and in an area protected from direct

contact with the weather. Do not install the SC unit in a hazardous location. The unit is

designed for an operating temperature range of 40 °F to 95 °F with a relative humidity of 20%

to 80% (non-condensing). Placing the SC unit in a dirty environment may cause premature

failures. The RS-485 junction box must be located within 8 feet of the SC unit. The RS-485

junction box must be grounded as specified in

“Power Requirements” on page 32. The SC unit

should not be placed on top of any other components and no other equipment should be placed

on top of the SC unit.

Figure 3-1: SC III

Notes:

1. Location of PC connectors may differ.

2. Ethernet Port and the USB may be disabled depending

on Operating System (OS) and PC settings.

Power Switch

PS/2 Mouse

PS/2 Keyboard

COM1/Serial1

Monitor

Printer

USB 1/2

Ethernet (Refer Note 2)

USB 3/4 (Refer Note 2)

Speaker

COM2/Serial 2

COM Ports 3-6

Power In

Port 1 Local RS-232

Port 6 RS-232

Port 5 RS-232

Loop1 Island RS-485 Port

Loop2 Island RS-485 Port

Factory Set to Two-wire for Tokheim

Loop3 POS High Speed RS-485 Port

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 85 86

Sem comentários

Gasboy CFN Series Site Controller III Manual do Utilizador Página 14