Gasboy CFN Series CFN II Quick Reference Manual do Utilizador descarregar pdf (Página 31)

CFN II Quick Reference

C09159 Rev. 2238 27

CPU Board, Firmware 5.3 & 5.4

CPU board assembly number: C05836.

There are no DIP switch banks on the Check Point

CPU board with this firmware version.

Pins 2 and 3 on K1 (next to U15) are normally

jumpered.

Any RS-232 (serial) printer connected directly to the

Check Point CPU board goes to P11; a parallel

printer goes to P12.

Check Point Test Mode

To begin a self test:

• turn keyswitch to MANAGER and press 00/NO

SALE, or

• disconnect the RS-422 connector, wait for the

Out of Service display, and press 00/NO SALE.

0 self-test

1 memory test

2 beeper check

3 console card reader test

4 display test

5 keyboard test

6 test opening of cash drawer

check setting of switches (firmware 5.2) or

configuration (firmware 5.3)

8 serial port/loopback test

CLEAR PRINT printer test (ver. 5.4 and higher)

9 ends self test

00 manager key test (firmware 5.3 or later)

Configuration

In the self test with firmware 5.3, pressing 7 accesses

configuration mode. (If the Check Point has never

been configured or if its configuration has been

erased, it will go into configuration mode at power

up.)

The default selection is the first selection shown in

each of the following option groups:

Option Menus

Selections

console address 1 2 3 4

keyswitch type 4 position

2 position

cash drawer yes no

drawer switch type dr clo=sw closed

dr clo=sw open

beeper enabled disabled

alert beep type short long no no

alert beep repetition* 15 sec 8 sec

4 sec 2 sec

key click type short medium

long none

LED color normal reversed

dead man timer on off

console printer/pad** No CONS PRNT/Pad

Console PRNT/Pad

printer address 01 01-64

DES disabled enabled

receipt line feed, top 0 1-10

receipt line feed, end 10 00-18

receipt left margin 04 00-10

printer Star undefined

printer port serial parallel

decimal position .00 none .0 .000

decimal point period comma

ignore scan 57 36-59, 62-77, 99

ignore scan 99 36-59, 62-77, 99

* in version 5.3e

** for Star RS-422 printer, set to No CONS PRINT/Pad

While an option in each group is displayed, pressing:

• ENTER selects the currently displayed option

and causes an option in the next group to display.

• 1 selects the next option in that group.

• 2 defaults to the first option in that group.

• 0 exits configuration mode and saves your

changes.

• PREV selects the currently displayed option and

displays the previous group.

• 7 returns you to the initial configuration display.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Comentários a estes Manuais

Sem comentários

Gasboy CFN Series CFN II Quick Reference Manual do Utilizador Página 31

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Gasboy CFN Series CFN II Quick Reference